If you did not assign cell codes when configuring the Optimize process in the pre-optimization flowchart, you must, in the post-optimization flowchart, segment the cells back into their original cells, and then assign cell codes.

The cell codes generated from the pre-optimization flowchart are available to you in the PCT and OCT, and can be output into your contact list as an Campaign Generated Field (UCFG). If the cell codes are needed only by your fulfillment vendor, this method may be sufficient. However, if you need the cell codes for analysis and reporting purposes, consider the following methods:

Use the CellCode field in the PCT and OCT, and output it into the ContactHistory table as an additionally tracked field.

This is an expensive way to store cell codes. Since you must repeat this procedure, the cell code is stored once per contact in the Contact history system table.

Re-segment by the cell codes in the OCT and PCT and then assign your final cell codes in the Segment process. This method allows you to use all the standard reporting by cell reports provided with Campaign. This is a best practice for managing cell codes.